Frequently Asked Questions
1. Will my sensors work with my gauges?2. Do my gauges require a voltage stabiliser?3. Where and how do I fit my minor gauge sensors?4. How do I fit my capillary type temperature gauges?5. Which is best, Ammeter or Voltmeter?6. Will my tachometer work with my vehicle's ECU (electronic control unit)?7. How do I wire up my RVI tachometer?8. What information is required to re-calibrate my speedometer? 9. What is the requirement for instruments for SVA Tests?10. How do I connect and calibrate my new Stepper Motor CAI Speedo?11. What sensor will I need to make my new electronic speedometer work?12. How do I fit my CAI fuel sender?13. What size holes do I need to cut in the dash for my new CAI instruments?14. What outer bezels are available?15. What gauge spares are available?16. What information do I need to give to make a new speedometer cable?17. Will my new cable fit my speedometer?18. Do I need an angle drive for my speedometer cable?19. How do I install and route my new speedo/tacho cable?20. What information do I need to give to make a new brake/clutch/throttle cable?21. What other cables can you make for my vehicle?
